Mobile Phone

+86-137 1193 0133

Call Us

+86-769-8873 4319

E-mail

cb@zgchuanbo.com
Contact Us

Address:North Square Road, Gaobu Town, Dongguan
Phone:+86-13711930133
Tel:+86-769-88734319

Industry News
Position: Home / News / Industry News

The laminating process and use matters of hot melt adhesive composite machine

Date:2021-06-01
Info:
 The laminating process of hot melt adhesive composite machine  While setting the guide rollers of t

  The laminating process of hot melt adhesive composite machine

  While setting the guide rollers of the substrate to the linear direction, adjust the viscosity according to the proportion, so that the composite machine will start the heating system of the oven. After reaching the corresponding set temperature, turn on the electric motor again to start the composite production. The record of the rolling device must first go through the anilox roller, apply the adhesive, and then go through the drying bath to complete the composite process.

Composite Machine

  Precautions for the use of hot melt adhesive composite machine

  1. Before production, check whether the cables, circuit breakers, contactors, motors and other electrical appliances of the hot melt adhesive compound machine meet the requirements.

  2. It is necessary to check whether the three-phase power supply is balanced before production, and it is strictly forbidden to start the equipment without phase.

  3. During the production process, check whether the rotary joint is safe, whether the pipeline is unblocked, whether there is damage or oil leakage, and remove it in time.

  4. Before production, check whether each connection is tight, whether there is any looseness or falling off, and repair it in time.


E-mail

cb@zgchuanbo.com

Phone

+86-13711930133

address

North Square Road,
Gaobu Town, Dongguan

WORKING TIME

08:30~17:30 Monday
to Saturday

Copyright © 2020 Dongguan Chuanbo Machinery Equipment Co., Ltd.
Home / News / Industry News

The laminating process and use matters of hot melt adhesive composite machine

  The laminating process of hot melt adhesive composite machine

  While setting the guide rollers of the substrate to the linear direction, adjust the viscosity according to the proportion, so that the composite machine will start the heating system of the oven. After reaching the corresponding set temperature, turn on the electric motor again to start the composite production. The record of the rolling device must first go through the anilox roller, apply the adhesive, and then go through the drying bath to complete the composite process.

Composite Machine

  Precautions for the use of hot melt adhesive composite machine

  1. Before production, check whether the cables, circuit breakers, contactors, motors and other electrical appliances of the hot melt adhesive compound machine meet the requirements.

  2. It is necessary to check whether the three-phase power supply is balanced before production, and it is strictly forbidden to start the equipment without phase.

  3. During the production process, check whether the rotary joint is safe, whether the pipeline is unblocked, whether there is damage or oil leakage, and remove it in time.

  4. Before production, check whether each connection is tight, whether there is any looseness or falling off, and repair it in time.



Dongguan Chuanbo Machinery Equipment Co., Ltd.